Armorpax

Armorpax · Posted: Sat Feb 27, 2010 7:36 pm Post subject: First of the Comet parts

Hi All,

Just a quick taster of a couple of the new parts for the Comet

Cheers

Dave

_________________

Armorpax · Posted: Sun Feb 28, 2010 12:38 pm Post subject:

_________________

Armorpax · Posted: Sat Mar 06, 2010 5:31 pm Post subject:

_________________

Armorpax · Posted: Sun Mar 07, 2010 5:06 pm Post subject:

_________________

Armorpax · Posted: Sun Mar 07, 2010 11:27 pm Post subject:

_________________

Armorpax · Posted: Sat Mar 13, 2010 5:20 pm Post subject:

Hi All,

HF "A" set Aerial Base now done,

Cheers

Dave

_________________

Armorpax · Posted: Sun Mar 14, 2010 7:57 pm Post subject:

Hi All,

Optional post war fishtail exhausts done,

Cheers

Dave

_________________

Armorpax · Posted: Tue Mar 16, 2010 12:10 am Post subject:

Hi All,

Turret Spot light done,

Cheers

Dave

_________________

Armorpax · Posted: Sat Mar 20, 2010 9:11 pm Post subject:

Hi All,

Commanders Hatch Retainer, Rear Deck Cover Handles, Glacis Grab Handle, Fuel Filler Cap and Rear Deck Cover Lock done.

Cheers

Dave

_________________

Armorpax · Posted: Sun Mar 21, 2010 7:58 pm Post subject:

Hi All,

Finally nearing the end of the Comet parts, below are the Loaders Hatch Handle and Retainer Catch, Transmission Oil Fillers, Infantry Phone Cable with Connectors and the Front Hatch Handles and Retainer Catches.

Just the Birdcage Gunsight to do and that will complete this run of parts.

Best regards

Dave

_________________

Armorpax · Posted: Thu Mar 25, 2010 11:39 pm Post subject:

Hi All,

Birdcage gunsight done. This is the last of the parts that will be included with the Armortek kit. I may make more detail parts once some of the other projects are done and if so these would be released as normal Armorpax items.

Best regards

Dave

_________________

Armorpax · Posted: Sat Apr 03, 2010 6:19 pm Post subject:

Hi All,

I have run most of the Comet parts in resin, prior to sending the masters off to have production moulds made for the metal parts.

Some of the multiple parts like the connector cables will have to wait for the production run but at least the Armortek prototype will now have most of its detail parts.

There is a lot of work to do now getting production masters, and then moulds ready, and metal kits should be available sometime in the summer

The pic below gives you a good idea of how much will be included with the Armortek kit. Not shown but also included are the various grab handles and connector cables mentioned above.

Best regards,

Dave

_________________